Locking, Unlocking with Request Switch (With the advanced keyless function)

All doors and the liftgate/trunk lid can be locked/unlocked by pressing the request switch on the front doors while the key is being carried.

(5–door)

The request switch on the liftgate can only be used to lock all doors and the liftgate.

Front doors

Liftgate (5-door Lock only)

To lock

To lock the doors and the liftgate/trunk lid, press the request switch and the hazard warning lights will flash once.

A beep sound will be heard once.

To unlock

Driver's door request switch

To unlock the driver's door, press the request switch. A beep sound will be heard twice and the hazard warning lights will flash twice.

To unlock all doors and the liftgate/trunk lid, press the request switch again within three seconds and two more beep sounds will be heard.

Front passenger door request switch

To unlock all doors and the liftgate/trunk lid, press the request switch. A beep sound will be heard twice and the hazard warning lights will flash twice.

 


  • The system can be set to unlock all doors by performing a single operation.

    Refer to Personalization Features (Search).

    Use the following procedure to change the setting.

    1. Switch the ignition off and close all of the doors and the liftgate/trunk lid.

    2. Open the driver's door.

    3. Within 30 seconds of opening the driver's door, press and hold the UNLOCK button on the key for 5 seconds or longer (the sound of the doors locking/unlocking can be heard).

      After this, the system switches the setting of pressing the driver's request switch once or twice to unlock all doors and the liftgate/trunk lid each time the UNLOCK button is pressed (the sound of the doors locking/unlocking can be heard).

    4. The setting change is completed by doing any one of the following:

      • Switching the ignition to ACC or ON.

      • Closing the driver's door.

      • Opening the liftgate/trunk lid.

      • Not operating the key for ten seconds.

      • Pressing any button except the UNLOCK button on the key.

      • Pressing a request switch.

  • Confirm that all doors and the liftgate/trunk lid are securely locked.

    For the liftgate/trunk lid, move it without pressing the electric liftgate/trunk lid opener to verify that the liftgate/trunk lid has not been left ajar.

  • All doors and the liftgate/trunk lid cannot be locked when any door or the liftgate is open.

  • It may require a few seconds for the doors to unlock after the request switch is pressed.

  • A beep sound is heard for confirmation when the doors and the liftgate/trunk lid are locked/unlocked using the request switch. If you prefer, the beep sound can be turned off.

    The volume of the beep sound can also be changed. Refer to Personalization Features (Search).

    Use the following procedure to change the setting.

    1. Switch the ignition off and close all of the doors and the liftgate/trunk lid.

    2. Open the driver's door.

    3. Within 30 seconds of opening the driver's door, press and hold the LOCK button on the key for 5 seconds or longer (All of the doors and the liftgate are locked and unlocked when the LOCK button on the key is pressed and held for 5 seconds.).

      The beep sound activates at the currently set volume. The setting changes each time the LOCK button on the key is pressed and the beep sound activates at the set volume. (If the beep sound has been set to not activate, it will not activate.)

    4. The setting change is completed by doing any one of the following:

      • Switching the ignition to ACC or ON.

      • Closing the driver's door.

      • Opening the liftgate/trunk lid.

      • Not operating the key for ten seconds.

      • Pressing any button except the LOCK button on the key.

      • Pressing a request switch.

  • (With theft-deterrent system)

    The hazard warning lights flash when the theft-deterrent system is armed or turned off.

    Refer to Theft-Deterrent System (Search).

  • The setting can be changed so that the doors and the liftgate/trunk lid are locked automatically without pressing the request switch.

    Refer to Personalization Features (Search).

    (Auto-lock function)

    A beep sound is heard when all doors and the liftgate are closed while the advanced key is being carried. All doors and the liftgate/trunk lid are locked automatically after about three seconds when the advanced key is out of the operational range. Also, the hazard warning lights flash once. (Even if the driver is in the operational range, all doors and the liftgate/trunk lid are locked automatically after about 30 seconds.) If you are out of the operational range before the doors and the liftgate/trunk lid are completely closed or another key is left in the vehicle, the auto-lock function will not work. Always make sure that all doors and the liftgate/trunk lid are closed and locked before leaving the vehicle. The auto-lock function does not close the power windows.

  • Auto re-lock function

    After unlocking with the request switch, all doors and the liftgate/trunk lid will automatically lock if any of the following operations are not performed within about 60 seconds. If your vehicle has a theft-deterrent system, the hazard warning lights will flash for confirmation.

    The time required for the doors to lock automatically can be changed.

    Refer to Personalization Features (Search).

    • Opening a door or the liftgate/trunk lid.

    • Switching the ignition to any position other than off.

Page top