How to Use the Driver Attention Alert (DAA)
Operating the DAA
The DAA operates when all of the following conditions are met and the system detects driver fatigue or decreased attentiveness based on deviation from the learned vehicle information.
-
The system detects white (yellow) lane lines.
-
One hour has passed since driving began.
-
The vehicle speed is about 65 km/h to 140 km/h (41 mph to 86 mph) for more than 20 minutes.
-
The system has completed an initial learning of vehicle information based on driving behavior during that driving session.
When the DAA is operating, the screen display and a warning sound will notify the driver that his/her attention level has decreased.
Instrument cluster (Type A)
-
“Time for a Break”
Instrument cluster (Type B)
-
“Time for a Break”
-
Driver behavior information from this feature is not transmitted outside the vehicle. The DAA does not operate if any of the following conditions is met.
-
The vehicle is making a sharp turn.
-
The vehicle is changing lanes.
-
-
The DAA may not operate normally if any of the following conditions is met.
-
The visibility of white (yellow) lane lines is poor.
-
The vehicle is jolted or swayed continuously by strong winds or rough roads.
-
-
The DAA detects driver fatigue and decreased attentiveness based on vehicle information when driving the vehicle at a vehicle speed between about 65 km/h and about 140 km/h (41 mph to 86 mph) for about 20 minutes. The learned vehicle information is reset and driver behavior information deleted when any of the following conditions is met.
-
The vehicle is stopped for 15 minutes or longer.
-
The vehicle is driven at less than about 65 km/h (41 mph) for about 30 minutes.
-
The vehicle power is switched OFF.
-
-
After the DAA has displayed the first message encouraging rest, it does not display the next one until 60 minutes have passed.
Turning off the DAA
Turn off the DAA using Mazda Connect.
Set in the Mazda Connect “Settings” or consult an Authorized Mazda Dealer.
For vehicles equipped with the driver monitoring camera, the DAA setting item is not displayed in Mazda Connect because the Driver Monitoring (DM) operation takes priority.
