Seat Belts

Fastening a Seat Belt

Before fastening a rear seat belt, make sure that the seat belt passes through the seat belt guide correctly and it is not twisted.

1. Sit back in the seat with your back upright.

2. Hold the plate and slowly pull out the seat belt.

   

    

   ---

   If the belt is locked and cannot be pulled out, retract the belt once, and then try pulling it out slowly. If this fails, pull the seat belt strongly one time and loosen it, then pull it out again slowly.

   Close Note

   View Note

3. Make sure that the belt is not twisted.

4. Insert the plate into the buckle until it clicks.

   

5. The belt should fit the pelvis as low as possible.

   

6. The belt should not touch the neck, jaw, or face and it should pass over the shoulder.

Seat belt indicator light (rear seat) (green)

The light turns on when the rear seat belt is fastened while the vehicle power is switched ON, and it turns off after a certain period.

 

Unfastening a Seat Belt

Make sure that the seat belt is not twisted, then let the seat belt retract slowly.

Adjusting the Seat Belt Height

If the seat belt contacts your neck or it slips off the shoulder, adjust the seat belt height.

To raise the seat belt

To lower the seat belt

1. Hold the seat belt anchor adjuster and press the knob down.

   

2. Make sure that the seat belt anchor adjuster is securely locked.